Chapter 4
61
Use the following procedure as a guide for computer problems.
1.
Obtain the failed symptoms in as much detail as possible.
2.
Verify the symptoms by attempting to re-create the failure by running the diagnostic test or by
repeating the same operation.
3.
If any problem occurs, you can perform visual inspection before you fellow this chapter’s instructions.
You can check the following:
power cords are properly connected and secured;
there are no obvious shorts or opens;
there are no obviously burned or heated components;
all components appear normal.
4.
After you perform visual inspection you can also verify the following:
ask the user if a password is registered and, if it is, ask him or her to enter the password.
verify with the customer that Wndows XP is installed on the hard disk. Operating systems that
were not preinstalled by Acer can cause malfunction.
make sure all optional equipment is removed from the computer.
make sure the floppy disk is empty.
5.
Use the following table with the verified symptom to determine which page to go to.
Symptoms (Verified)
Go To
Power failure. (The power indicator does
not go on or stay on.)
“Power System Check”
POST does not complete. No beep or error
codes are indicated.
“Insyde MobilePro BIOS POST Beep Code
and POST Messages”
“Undetermined Problems”
POST detects an error and displayed
messages on screen.
“Insyde MobilePro BIOS POST Beep Code
and POST Messages”
Other symptoms (i.e. LCD display problems
or others).
“Insyde MobilePro BIOS POST Beep Code
and POST Messages”
Symptoms cannot be re-created
(intermittent problems).
Use the customer-reported symptoms and
go to “Insyde MobilePro BIOS POST Beep
Code and POST Messages” on page 67
“Intermittent Problems”
“Undetermined Problems”
Troubleshooting
Chapter 4
