Chapter 2
25
PS/2 Mouse
Enable or Disable PS/2 Mouse port IRQ12.
Option:
Enabled
, Auto Detect, or
Disabled
IDE Controller
Configure the Integrated Local Bus IDE
Controller.
Option:
Disabled
or Enabled
On Chip SATA
Enable On chip SATA.
Option:
Enabled
or Disabled
SATA Mode
Select the SATA Mode.
Option:
IDE-ACHI
or IDE Native
SATA Smbus
Interface
Enable or disable the SATA Smbus
Interface.
Option:
Enabled
or Disabled
USB Host
Controller
Enable or disable USB hardware.
Option:
Enabled
or Disabled
Legacy USB
Support
Enable support for Legacy Universal Serial
Bus.
Option:
Enabled
or Disabled
Option ROM
Placement
Determines which peripheral devices can
be booted.
NOTE:
Changes to this setting can cause
the system to halt during boot.
Option:
Disabled
, Temporary, or
E000 Extend
Gigabit Lan
Enable or disable the on board Gigabit
LAN.
Option:
Enabled
or Disabled
Network Boot
Enable to support LAN on mainboard boot
or disable for faster stand alone boot.
Option:
Enabled
or Disabled
Large Disk Access
Mode
Set the Large Disk Access mode. Different
O/S require different drive geometry
representations. Select Other for UNIX,
Novell NetWare, or other O/S.
Option:
DOS
or Other
Installed O/S
Set the most commonly used O/S on the
system.
Option:
Other
, Win2000, WinMe,
Win98, or Win95
Reset
Configuration Data
Clear Extended System Configuration Data
(ESCD) area.
Option:
No
or Yes
Processor
Assisted
Virtualization
Enable the hardware visualization support.
Option:
Enabled
or Disabled
Parameter
Description
Submenu Items
Summary of Contents for Aspire 5515
