4
Chapter 1
On-board connectors
•
1 AM3 CPU socket
•
4 DDR3 memory sockets
•
1 PCI Express x16 slot
•
2 PCI Express x1 slot
•
1 PCI slots
•
6 SATA2 connectors
•
Four 2x5-pin Intel FPIO specification USB pin connectors (follow Intel FPIO Standard Specification)
•
One 2x5-pin Intel FPIO spec Microphone In/ Headphone Out pin connector
•
One 1x4 S/PDIF out header (for ALC662 SKU)
•
One 3-pin CPU fan connector (co-lay with 4-pin CPU fan connector)
•
One 3-pin system fan connector with linear circuit
•
One 24-pin + 4-pin ATX interface PS3/PS2 SPS connector
•
One 2x7-pin front panel I/O header
•
1 Jumper for clear CMOS
•
1 on board buzzer
•
2 reserved 2-pin GPIO connector
System BIOS
•
Size: 8Mbit
•
AMI Kernel with Acer skin/copyright
Power supply
•
300W in stable mode (Acer Assign System Power Unit)
•
Support 82+ PSU for EnergyStar 5.0 complaint
•
Design for SB810 series chipset compatible system
•
Voltage design should be c5V, +3.3V, +12V, +5VSB, -12V (attention to 12V output capability)
•
Demand for both PFC/Non-PFC solutions (two different quotations are needed)
•
Minimum 4 Serial ATA power connector solution should be included (by default)
•
Minimum 1 big 4-pin power connector included
•
Minimum 1 small 4-pin power connector included
•
PFC version will not provide switch selector for 115/230V AC input but it should be universal for Europe
and China
•
Non-PFC version should provide switch selector for 115/230V AC input and universal for worldwide
•
PS2 style.
Summary of Contents for Aspire M3410
