Chapter 4
63
USB eModule Error Messages
SMBIOS eModule Error Messages
CPU eModule Error Messages
MPS Table (Multi-processor) eModule Error Messages
Message Displayed
Description
Warning!
Unsupported USB
device found and
disabled!
This message is displayed when a non-bootable USB device is enumerated and
disabled by the BIOS.
Warning! Port 60h/
64h emulation is not
supported by this
USB Host Controller!
This message is displayed to indicate that port 60h/64h emulation mode cannot be
enabled for this USB host controller. This condition occurs if USB KBC emulation
option is set for non-SMI mode.
Warning! EHCI
controller disabled. It
requires 64bit data
support in the BIOS.
This message is displayed to indicate that EHCI controller is disabled because of
incorrect data structure. This condition occur if the USB host controller needs 64-bit
data structure while the USB is ported with 32-bit data structure.
Message Displayed
Description
Not enough space in
Runtime area!!.
SMBIOS data will not
be available.
This message is displayed when the size of the SMBIOS data exceeds the
available SMBIOS runtime storage size.
Message Displayed
Description
Warning! This system
board does not
support the power
requirements of the
installed processor.
The processor will be
run at a reduced
frequency, which will
impact system
performance.
This message is displayed when the power requirements of the board do not match
the power requirement of the CPU.
Message Displayed
Description
Insufficient Runtime
space for MPS data!
System may operate
in PIC or Non-MPS
mode.
This message is displayed when there is not enough space in the 0F000h runtime
area for creating MPS table.
Summary of Contents for ASPIRE X5300
