11n : 11dBm ± 2dB
Receive Sensitivity
802.11b: under -83dBbm at 11Mbps
802.11g: under -70dBm at 54Mbps
802.11n: under -67dBm at MCS 7 (2.4GHz only)
Antenna
Single antenna
(without diversity)
Support 2.4GHz band.
Performance should meet test summary document released by Acer DQM.
Bluetooth® 3.0
Module
Broadcom BCM4330
MAC address
Device must contain Bluetooth MAC address before shipment
Support Profiles
A2DP 1.2 (Advanced Audio Distribution Profile)
AVCTP 1.0 (Audio/Video Control Transport Protocol)
AVDTP 1.2 (Audio/Video Distribution Transport Protocol)
AVRCP 1.0 (Audio/Video Remote Control Profile)
OBEX 1.0
PAN 1.0
PBAP 1.1
Frequency Range
2.4 GHz (2.400 ~ 2.4835 GHz)
Modulation
GFSK, π/4 DQPSK and 8DPSK
Channel
79 channels
Data Rates
Basic data rates: GFSK (1Mbps)
EDR data rates: π/4 DQPSK (2Mbps) and 8DPSK (3Mbps)
Operating Range
10m
Output Power
Class 2 (-6dBm~4dBm)
Receive Sensitivity
Under –80 dBm, BER of 0.1%
Antenna
Share the same antenna from WiFi
Performance should meet test summary document released by Acer DQM.
GPS
Chipset
WIFI SKU: SiRFstar CSRG05t-WLCSP (Support GPS & GNSS)
Channel
Tracking: 36 (running concurrently with the acquisition channels)
Acquisition: 100-200 (flexible non-real time architecture)
Sensitivity
High-sensitivity tracking to -165 dBm
Accuracy
Hot start: less than 5 seconds (* subject to test environments)
Warm start: less than 5 seconds (* subject to test environments)
Cold start: less than 35 seconds (* subject to test environments)
Position: within 10m for 90%
Velocity: 0.1m/s (* subject to test environments)
Protocol
Available in the Host-based SiRFnav software
The protocol function provides the capability to input
and output messages that conform to the required
protocols, including OSP and NMEA
Summary of Contents for Iconia One 7 B1-730HD
