Altos R520 Installation Configuration Guide
156
# cd /tmp/
# unzip ir3_Linux_RWC2_v1.13-00.zip
# chmod 755 install.sh
# chmod 755 RunRPM.sh
# ./install.sh
3.
Type y to accept the license agreen and select 1 for full installation.
4.
To start RAID Web Console 2, click on start button, select System -> More
Programs -> RAID Web Console 2 Startup UI
NetWare 6.5 SP5 Installation (with integrated SAS hardware
RAID)
Below information describes how to manually install NetWare 6.5 (Support
Pack 5 overlay CD) on Altos R520 with integrated SAS hardware RAID.
Drivers Required
For NetWare 6.5 SP5 installation with integrated SAS hardware RAID, the
following device drivers are required.
Device Version
EasyBUILD Version
Integrated SAS
hardware RAID
1.00.07
EasyBUILD 7.1 build 400 (or later)
Onboard Chipset
N/A
OS built-in
Onboard Gigabit
Ethernet
9.22
EasyBUILD 7.1 build 400 (or later)
Onboard VGA
N/A
OS built-in
Onboard USB 2.0
N/A
OS built-in
Configuring integrated SAS hardware RAID
Please refer to the Appendix A. for the integrated SAS hardware RAID
configuration.
Installation Tips
NOTE. There is no built-in driver of integrated SAS hardware RAID in the
NetWare 6.5 SP5. You need an external USB floppy drive to load driver during
the OS installation.
1.
Make a driver diskette for integrated SAS hardware RAID and onboard
Intel 82563EB Gigabit Ethernet from EasyBUILD.
2.
Boot the system from the NetWare 6.5 SP5 OS CD.
3.
At Welcome to the NetWare 6.5 server installation page, select Manual to
install.
4.
At Prepare boot partition page, create one 500 MB DOS partition.
