Altos R520 Installation Configuration Guide
168
15. Press Enter again to select array to configure.
16.
Press spacebar to select the array and press <F10> to configure the logical
drive
17.
The default RAID level for 2 disk drives is RAID1. Just select Accept to use
the default setting and press <Enter> to return to the
ARRAY SELECTION
MENU.
18.
Press <Enter> to end the array configuration.
19.
Select YES to Save Configuration and press any key to return to the
Configure menu.
Initial RAID Volume
20.
Press <Esc> to return to the Management Menu.
21.
Select Initialize from Management menu. All logical drives should be
listed under Logical Drives.
22.
Press <Spacebar> to select drives for initialization. The selected drive will
be shown in yellow.
23.
After selecting the drives, press <F10> and select YES to start the
initialization process.
24.
When initialization is complete, press any key to continue.
25.
Press <Esc> to return to the Management Menu.
Save and Exit Embedded RAID II Configuration Utility
26.
When RAID configuration and initialization is complete, press <Esc> in the
Management Menu and select YES to exit the Embedded RAID
Configuration Utility.
27.
Press <Ctrl> + <Alt> + <Del> to reboot the server.
