Altos R520 Installation Configuration Guide
50
Onboard VGA
8.24.3-
060405a-
038923C-Intel
EasyBUILD 8.0 build 200 (or later)
Onboard USB 2.0
N/A
OS built-in
IOAT
1.2.79.9
EasyBUILD 8.0 build 200 (or later)
Hot-swap
backplane
5.0.6262.1
EasyBUILD 8.0 build 200 (or later)
Software Required
The management utility of integrated SAS hardware RAID 2 can be found in
the EasyBUILD.
Software Version
EasyBUILD
Version
Microsoft Scalable
Networking Pack
N/A
http://www.microsoft.com/downloads/
details.aspx?FamilyID=c65f4a89-f4da-
463e-a496-
4b5abd660bf9&DisplayLang=en
RAID Web Console
2
2.63
EasyBUILD 8.0 build 200 (or later)
Intel PROSet Utility
13.0.44.0
EasyBUILD 8.0 build 200 (or later)
Configuring integrated SAS hardware RAID 2
Please refer to the APPENDIX D. for the integrated SAS hardware RAID 2
configuration.
Installation Tips
NOTE. There is no built-in driver of Integrated SAS hardware RAID 2 in the
Windows Server 2003. You need an external USB floppy drive to load driver
during the OS installation.
1.
As Windows Server 2003 can’t recognize the integrated SAS hardware
RAID 2, you need to make a driver diskette from the EasyBUILD first
before the installation.
2.
Press F6 at the start of installation to provide the driver disk for the
integrated SAS hardware RAID 2.
3.
Select “Intel(R) SAS RAID Controller Driver (Server 2003 32-bit)” as target
driver
4.
After loading the RAID driver from diskette, follow the normal procedure
to finish the installation.
Chipset Driver Installation
1.
After the installation completes, you would see the following devices
with yellow mark in Device Manager.
