Altos R520 Installation Configuration Guide
68
Advanced Server SP4 on Altos R520 with integrated SAS SW RAID.
Drivers Required
For Windows 2000 Installation, the following device drivers are required.
Device Version
EasyBUILD Version
Integrated SAS SW
RAID
04.24.0620.20
06
EasyBUILD 7.1 build 400 (or later)
Onboard Chipset
7.4.0.1005
EasyBUILD 7.1 build 400 (or later)
Onboard Gigabit
Ethernet
9.3.39
EasyBUILD 7.1 build 400 (or later)
Onboard VGA
8.24.3.0
EasyBUILD 7.1 build 400 (or later)
Onboard USB 2.0
N/A
OS built-in
IOAT
1.2.52.0
EasyBUILD 7.1 build 400 (or later)
Software Required
The management utility of integrated SAS SW RAID can be found in the
EasyBUILD.
Software Version
EasyBUILD
Version
RAID Web Console
2
1.13-07
EasyBUILD 7.1 build 400 (or later)
Intel PROSet Utility
10.4.4.2
EasyBUILD 7.1 build 400 (or later)
Configuring integrated SAS SW RAID
Please refer to the Appendix B. for the integrated SAS SW RAID configuration.
Installation Tips
NOTE. There is no built-in driver Integrated SAS SW RAID in the Windows
Server 2003. You need an external USB floppy drive to load driver during the
OS installation.
1.
As Windows 2000 can’t recognize the integrated SAS SW RAID, you need
to make a driver diskette from the EasyBUILD first before the installation.
2.
Press F6 at the start of installation to provide the driver disk for the
onboard ROMB.
3.
Select “Intel Embedded Server RAID Technology II (Windows 2000 SP4)”
as target driver
4.
After loading the driver from diskette, follow the normal procedure to
finish the installation.
Chipset Driver Installation
1.
After the installation completes, you would see the following other
devices listed in Device Manager.
