First things first
Acer p600 Series Portable Navigator setup
xiv
Acer p600 Series Portable Navigator setup
Using your new Acer p600 Series Portable Navigator for the first time is a snap.
Unpack, turn on, mount, and you’re ready to go. Perform the following easy
installation tasks to start using the device straight out of the box:
1
Unpack the device
2
Turn on and configure the device.
3
Set up the device in your vehicle.
NOTE: After powering your device on for the first time by moving the power switch to the
right (see diagram above), you should not use the power switch again unless you want to do a
hard reset. See "Performing a hard reset" on page 33 for more information. Instead, use the
power button at the top of the device (see diagram below).