PC 2120 All-in-One 12.1” TFT LCD Panel PC User’s Manual
3.11
USB and Dallas Key Installation
To install an USB device or to access a Dallas key to the system from
side panel, you must get access to the connectors located on the side
panel. Take off the dust/spill cap located at the side panel by pushing
it downward to loosen its grip on top. Once loosened, pull the cap
upward to disengage completely.
3.12
System O/S and Software Installation
The PC 2120 series is not equipped with any operating system. It
reserves a 3.5” HDD drive bay for its storage device space. As both
devices are built in the system chassis, to load any O/S or application
software into the computer, an external device is needed to act as a
bridge. There are three major ways to load software into the system.
z
Use an external USB flash memory:
Attach a USB flash memory to the USB port. Then,
configure the system BIOS setup and containing
necessary software and start the installation.
z
Use Ethernet:
If the Ethernet bootrom is already included in the system,
the user can boot up the system via bootrom and
download the system O/S or application software from
the net.
z
Use external USB CD-ROM/ HDD:
Attach a USB CD-ROM or USB HDD to the USB port. Then,
configure the system BIOS setup and containing
necessary software and start the installation.
22
Hardware Installation
Summary of Contents for PC2120
Page 1: ...PC2120 All in One 12 1 TFT LCD Panel PC User s Manual ...
Page 8: ...This page does not contain any information viii ...
Page 13: ...PC 2120 All in One 12 1 TFT LCD Panel PC User s Manual 1 4 Dimensions Introduction 5 ...
Page 25: ...PC 2120 All in One 12 1 TFT LCD Panel PC User s Manual Hardware Installation 17 ...