Altos R5250 Installation Configuration Guide
90
RAID \
Onboard NVIDIA
NFP3600 Chipset
N/A OS
built-in
Onboard NVIDIA
nForce Networking
Controller
0.62 \Disk\R5250\NIC\Nvidia\rhel5\
Onboard XGI Z9s
1.12.03
\Disk\R5250\onboard\xgiz9s\rhel5\
ATI FireGL V5200
8.35.5
\Disk\R5250\graphic\V5200\rhel5\
Software Required
The management utility for onboard SATA RAID can be found in the EasyBUILD
8.0 build 100 (or later).
Software
Version
Directory on EasyBUILD
Onboard SATA
RAID utility
9.44 \app\R5250\onboard\sataraid\Linux\rhel
5\
Configuring onboard SATA RAID
Please refer to the Appendix A. for the Onboard SATA RAID Configuration.
Installation Tips
1.
Since Red Hat Enterprise Linux 5 cannot recognize the onboard SATA
RAID, you need to make a driver diskette from the EasyBUILD 8.0 build
100 (or later) first before the installation.
2.
Type linux dd when the prompt boot: appears at the start.
3.
Please select the sda as the Driver Disk Source.
4.
Follow the instruction to load the onboard SATA RAID driver from the
driver diskette.
5.
At the Package Installation Defaults, select Customize software packages
to be installed.
6.
At the Package Group Selection step, select Graphic Internet under
Applications.
7.
If you have installed the ATI FireGL V5200 in the system, please also select
Development Tools and under Development. If you don’t have ATI FireGL
V5200, please go to next step directly
8.
After adding the additional packages, follow the normal procedure to
finish the installation.
Gigabit Ethernet Driver Installation
The Gigabit Ethernet driver installation is the same as SAS daughter board
installed. Please refer to the Red Hat Enterprise Linux 5.0 Installation (SAS
Daughter Board) Gigabit Ethernet Driver Installation section.
