95 Altos R5250 Installation Configuration Guide
system into text mode and install the driver for ATI FireGL V5200 first.
NOTE. For installing the ATI FireGL V5200 driver, additional packages are
required. Please refer to the Installation Tips section for which packages should
be installed.
1.
When the system stopped after OS installation completed, please power
off the system than power on it again.
2.
Please select SUSE Linux Enterprise Server 10 (Failsafe) at boot select
menu.
3.
After you the system boot into text mode, copy the ATI driver installer to
HDD.
4.
Go to the directory that includes the ATI driver installer and run the ATI
driver installer.
# ./ati-driver-installer-8.35.5-x86.x86_64.run
5.
Follow the instructions and use the default settings to install the driver.
6.
After the driver is installed, run “aticonfig --initial” to configure the
driver.
# aticonfig –-initial
Uninitialised file found, Configuring.
Using /etc/X11/xorg.conf
Save back-up to /etc/X11/xorg.conf.original-0
7.
Please reboot the system.
8.
If you want to change the display setting, please DO NOT use the OS
built-in utility. Please use the ATI Catalyst Control Center instead by
“amdcccle” command.
# amdcccle
Gigabit Ethernet Driver Installation
1.
You can find the onboard NVIDIA nForce Networking Controller driver in
EasyBUILD 8.0 build 100. Please refer to Directory on EasyBUILD in Driver
Required section.
2.
After you insert the EasyBUILD 8.0 build 100 into the optical drive, it will
be mounted automatically. Please copy the driver from the EasyBUILD 8.0
build 100 to HDD first.
# cp /media/EBV71B600/
Disk/R5250/nic/Nvidia/x64/sles10/
nvlan-sles10-0.62-1.23.x86_64.rpm
/tmp
3.
Install the driver
# cd /tmp
