66
Chapter 3
Reinstalling the VGA Card
1.
Position the expansion board over the PCIE16X 1 slot and move it slightly to the right (1), making sure the
card guide is aligned with the slot guide on the chassis. Insert the expansion card properly connector into
PCIE16X 1 slot (2).
2.
Secure the expansion board bracket opposite the PCIE16X 1 slot using one screw.
Summary of Contents for SX2830
