70
English
Create factory default image CD
When the System CD and Recovery CD are not available, you can create them by
using this feature.
1
Boot to Windows XP.
2
Press <Alt> + <F10> to open the Acer eRecovery Management utility.
3
Enter the password to proceed. The default password is six zeros.
4
In the Acer eRecovery Management window, select Recovery settings and
click Next.
5
In the Recovery settings window, select Burn image to disk and click Next.
6
In the Burn image to disk window, select 1. Factory default image or
2. Application CD and click Next.
7
Follow the instructions on screen to complete the process.
Note: Select 1. Factory default image when you want to burn a
bootable disk that contains your computer's entire operating
system as it was delivered to you from the factory. If you wish to
have a disk that will allow you to browse the contents and install
selected drivers and applications, select 2. Application CD — this
disk will not be bootable.
Re-install bundled software without CD
Acer eRecovery Management stores pre-loaded software internally for easy
driver and application re-installation.
1
Boot to Windows XP.
2
Press <Alt> + <F10> to open the Acer eRecovery Management utility.
3
Enter the password to proceed. The default password is six zeros.
4
In the Acer eRecovery Management window, select Recovery actions and
click Next.
5
In the Recovery settings window, select Reinstall applications/drivers and
click Next.
6
Select the desired driver/application and follow the instructions on screen
to re-install.
At first launch, Acer eRecovery Management prepares all the needed software
and may take few seconds to bring up the software content window.
Summary of Contents for TravelMate 6500
Page 1: ...TravelMate 6500 Series User s Guide ...
Page 20: ...6 Empowering Technology ...
