8
Electrical Requirements
Standard Test Conditions
All tests shall be performed under the following conditions, unless otherwise specified.
Ambient light
Dark room (< 1 cd/m2)
Viewing distance
40 cm for LCD performance, 20 cm for LCD failures
Warm up time
＞
30 minutes
Analog Input signal
700 mVss
Control temperature
6500
°
K (e-Color set to “User” mode)
Brightness control
The value under user mode
User contrast control
Set to The value under user mode, which allows that the brightest
two of 32 linear distributed gray-scales (0
～
700mv) can be
distinguished.
Picture position and size
Factory preset value
Viewing angle
90 ° H and V
AC Supply voltage
230V± 5
％
, 50±3Hz
Ambient temperature
20+5
℃
Humidity
65%
±
20%
Display mode
1680x1050, 60 Hz, all white
e-color mode
Set to “User” mode
Measurement systems
The units of measure stated in this document are listed below:
1 gamma = 1 nano tesla
1 tesla = 10,000 gauss
cm = in x 2.54
Lb = kg x 2.2
Degrees F = [°C x 1.8] + 32
Degrees C = [°F - 32]/1.8
u' = 4x/(-2x + 12y + 3)
v' = 9y/(-2x + 12y + 3)
x = (27u'/4)/[(9u'/2) - 12v' + 9]
y = (3v')/[(9u'/2) - 12v' + 9]
nits = cd/(m2) = Ft-L x 3.426
lux = foot-candle x 10.76
Summary of Contents for V203W
