60
Standard Disassembly Procedure
This section tells you how to disassemble the system when you need to perform system service. Please also
refer to the disassembly video, if available.
CAUTION:
Before you proceed, make sure you have turned off the system and all peripherals connected to it.
Opening the Housing
This section tells you how to open the housing cover when you need to install additional components inside
the system unit.
CAUTION:
Before you proceed, make sure that you have turned off the system and all peripherals connected
to it.
Removing the Housing
1.
Remove the two screws holding the upper cover.
2.
Slide the upper cover out and then gently pull it outward to detach it from the housing.
Removing the ODD/FDD/SATA HDD
1.
Remove one screw holding the bracket holder.
2.
Remove the bracket holder..
3.
Disconnect the ODD power cables and ODD cables from the ODD.
Summary of Contents for Veriton 3700G
