Chapter 3
54
Opening the Housing
This section tells you how to open the housing cover when you need to install additional components inside
the system unit.
CAUTION:
Before you proceed, make sure that you have turned off the system and all peripherals connected
to it.
Removing the Housing
1.
Turn off the system power and unplug all cables.
2.
Place the system unit on a flat, steady surface.
3.
Remove the four screws of the right panel and left panel using a screwdriver. Set the screws aside, you
will need them when replacing the panel of the unit.
4.
Slide the right panel out and then gently pull it outward to detach it from the housing. Do the same thing
to the left panel.
.
Summary of Contents for VERITON 7200
