Acer VT0 Series, User Manual

English

Acer LCD Monitor Quick Start Guide (QSG)

Important safety instructions

Please read the following instructions carefully.

1.  To clean the LCD monitor screen: 

• 

Turn off the LCD monitor and unplug the power cord.

• 

Spray a non-solvent cleaning solution onto a rag and clean the screen gently.

2.  Do not place the LCD monitor near a window. Exposing the monitor to rain, moisture or sunlight can severely damage 

it. 

3.  Do not apply pressure to the LCD screen. Excessive pressure may cause permanent damage to the display. 

4.  Do not remove the cover or attempt to service this unit yourself. An authorized technician should perform servicing of 

any nature. 

5.  Store the LCD monitor in a room with a temperature of -20°C to 60°C (-4°F to 140°F). Storing the LCD monitor 

outside this range may result in permanent damage.

6.  Immediately unplug your monitor and call an authorized technician if any of the following circumstances occur:

• 

Monitor-to-PC signal cable is frayed or damaged. 

• 

Liquid spills onto the LCD monitor or the monitor is exposed to rain. 

• 

The LCD monitor or case is damaged. 

Attaching the monitor to the base

1.  Remove the monitor from the packaging.

2.  Attach the footstand to the base. (for selected models).

3.  Turn clockwise to lock. Ensure that the base in locked onto the stand. (for selected models)

4.  Secure the base to the stand by turning the screw using the intergrated tab or a suitable coin. (for selected models)

Connecting your monitor to a computer

1. 

Turn off your computer and unplug your computer's power cord.

2.  Connect the signal cable to VGA (Optional) and/or HDMI (Optional) 

input socket of the monitor, and the VGA (Optional) and/or HDMI 

(Optional) output socket of the graphics card on the computer. Then 

tighten the thumbscrews on the signal cable connector.

3.  USB Type B Cable (Optional, USB Type B input models only) 

Connect one end of the USB Type B cable (optional) to your 

computer and connect the other end to your electric devices. 

Connect the USB Type B (3.0) cable to port for fast charge (5V/1.5A). 

Connect the USB Type B (3.0) cable to port.

4.  Insert the monitor power cable into the power port at the back of the 

monitor.

5.  Plug the power cords of your computer and your monitor into a 

nearby electrical outlet. 

Note: Audio output is only for audio output model. Please check user   

manual for more instruction.

USB 3.0 (5V/1.5A)

AdaptiveSync (HDMI): 

It can allow a AdaptiveSync supported graphics source to dynamically adjust display refresh rate based on typical content 

frame rates for power efficient, virtually stutter free and low-latency display update.

1

2

3

4

5