8
... English
Acer WP100
Setting up your WPG
You need to set up your WPG before you can use it. This is achieved by
simply plugging the WPG into your projector's DVI port. There are three
possible ways to provide power to your WPG:
1. Some projector models support powering the WPG through the DVI
port.
2. Some projectors have a built-in DC-out jack that you can use to
provide power to the WPG. Ensure that your projector supplies 5 V
DC if it is equipped with a DC-out jack.
3. Use the power adapter to supply power to the WPG.
If your projector is not equipped with a DVI connector, you can
attach the bundled DVI-to-VGA converter to the DVI connector
of the WPG, and then plug the VGA connector of the converter
into the projector.
Check the LED for the power status.
· Red indicates that the WPG is receiving power, but is inactive.
· Green indicates that the WPG is being used to project images.
You may also like to connect a LAN cable to the LAN (RJ-45) port on
the side of the dongle. This will allow you to connect to the Internet
to retrieve interactive content or download firmware upgrades as they
become available.
Summary of Contents for WP100
Page 1: ...Acer WP100 User s Guide ...
Page 4: ...Acer WP100 ...
