41
2. Assembly FM Module:
Place FM on “HLD FM” surface(Fig. 2-1) and use “Clip FM” to fix FM(Fig. 2-2).
Fig. 2-1
Fig. 2-2
3. Assembly HSG ILL Module:
3.1 CM Assembly
I. Insert “Clip CM Side” first, and then place “Clip Front CM” to fixed-shaft of ILL SUB
before locking screw (Fig. 3-1, Fig. 3-2).
II. Assemble CM to HSG ILL and to make CM contact three datum on the HSG ILL
Well (Fig. 3-3).
III. Assemble “CLIP TOP CM” (with forceps) to the “HSG IL” (Fig. 3-4,).
IV. To check and make sure “CLIP of CM” hooks the HSG ILL very Well (Fig. 3-5).
V. Paste “Sponge tube AL” on cannelure of” HSG ILL” (Fig. 3-6).
6.2 FM Module Assembly
1. FM Module must be placed to fixed shaft and on the datum surface of “ILL SUB”
and then lock with screw well (Fig. 3-7).
Fig. 3-1
Fig. 3-2
Screw
8F.1A752.3R0
Clip CM Side
Fixed shafts
of ILL SUB
Touch the
side surface
Clip FM hook
the punch points
Summary of Contents for X1230S Series
