19
Alarm configuration: in the alarm configuration interface can check the alarm
way: audible alarm, trigger alarm and e-mail alarm
Trigger recording: check the trigger channel at "trigger video" interface, . Click
"OK" to save the above settings, click "Exit" to exit the current interface channel.
Alarm linkage: set the alarm type and linkage type at linkage alarm interface, such
as preset positions, cruise line or track (Note: these three is already applicable in
before PTZ configuration, click "OK" to save above settings when the corresponding
channel alarm input, PTZ start a preset point,cruise lines and trajectories. Click "Exit" to
exit the current interface.
Pic 2-20
Alarm handling - alarm linkage
User can setup all channels with same parameters, please tick off “All”, and then to
do relevant setup.
。
Click “Default” button to resort default setting; click “Apply” button to save the setting;
click “Exit” button to exit current interface.
2.4.5.2 Motion
Motion includes one sub menus: motion
1>
Motion
Pic 2-21
Motion
Click start motion alarm and set alarm hold time
，
It refers to after close motion alarm it
delay to the preset setting time. Click alarm "Settings" button, show below window
：
