P3 -
KILL A WATT
TM
Operation Manual
1. The LCD shows all meter readings: Volts, Current, Watts, Frequency, Power
Factor, and VA. The unit will start to accumulate
kWh
and powered duration time
(hours & minutes) after power is applied.
2. Press Volt Key for true RMS Voltage (
Volts
) display.
3. Press Amp Key for true RMS output current (
Amps
) display.
4. The Watt/VA Key is a toggle function key. Press the Watt/VA key once to display
Watt meter
, then press the Watt/VA key again to display
VA meter
. The LCD will
display Watts as the active power, where VA is the apparent Power.
(VA = Vrms * Arms)
5. The HZ/PF is a toggle function key. Press the HZ/PF key once to display the
frequency (
Hertz
), then press key again to display the
Power Factor
. HZ is the
Frequency of output Voltage, where PF is the Power Factor (PF = W / Vrms Arms).
6. The KWH/Hour is a toggle function key. Press the KWH/Hour key once to show
the cumulative energy consumption since power was applied to the unit (
kWh
).
Then press key to display the cumulative time since power was applied to the unit.
7. Consumption will be displayed in Kilowatt-Hours (from 0.01 KWH to 9999 KWH).
Time will initially be displayed as Hours:Minutes (from 00:00) and switch to Hours
(to 9999). Counters will recycle to zero when they reach their maximum.
8. To reset all counters to zero, remove power from unit momentarily for about 15
seconds.
Copyright © 2012-2015 American Custom Golf Cars, Inc.
Page
75