PCIe Accelerator-6D Card User Guide (UG074)
14
Speedster FPGAs
1.
2.
3.
Figure 6:
Standalone Board Connections
Connecting the Host PC
Based on the system requirements, the following are the connections needed to the host PC:
Connect the supplied micro-USB cable the to the "USB Connector for FTDI" (see figure:
) for programming the FPGA and/or accessing HD1000's internal
registers via FTDI over JTAG.
Connect the second supplied micro-USB cable to the "DCC Micro-USB Connector" (see figure:
) for accessing the HD1000's internal registers via DCC.
Accelerator-6D Board Details (see page 9)
Connect the extended Gen3 ×8 PCIe connector to the PCIe edge connector on the board (see figure:
PCIe Accelerator-6D Board Details (see page 9)
Connecting the Power Supply
Although the individual components on the board use different voltage levels, each of these is generated on the
board using a single 12V power supply input.
