Installer’s Guide
20
To
revert to factory presets
,
hold
both
the
AUX1
and
AUX2
Prefade
buttons in while
switching ON your system’s power (including the
VGM-1041
). You’ll see their LEDs blink in
confirmation. This resets the following functions:
•
All MIC channels
on the Voice sound path, De-ess ON.
•
MIC 3
set as the
chairperson’s
or
main
stage mic:
Compression and Stage Monitor OFF
Gate Threshold low
•
All other MIC
channels set for general use:
Compression and Stage Monitor ON
Gate Threshold moderate
•
Equalization:
Individual MIC EQs flat. Voice and Music EQ preset to improve typical
auditorium sound “out of the box.” Of course, you can alter these via USB; you can
also automatically set the Voice EQ via Auto EQ (see page 36).
Voice EQ:
Frequency Bandwidth Gain/Atten
141 Hz 1/3 octave -6 dB
355 Hz 3/2 octave -6 dB
1002 Hz 1/3 octave -3 dB
1261 Hz 1/3 octave -3 dB
1782 Hz 1/2 octave -3 dB
4477 Hz
1/3 octave -3 dB
7962 Hz 3/2 octave +4 dB
Music EQ:
71 Hz 1 octave +4 dB
316 Hz
2 octaves -6 dB
7962 Hz 3/2 octave +4 dB
Choosing a different “main” mic channel
If your “main” or “chairperson’s” main stage microphone is on a channel
other than
MIC 3
, set your mixer accordingly by holding down the
Prefade
button
for this mic channel while powering up your system. Your mixer saves your
choice until you change it again or do a factory reset (above).
C O M P R E S S
AUX 2
VGM1041
1
AUX 1
Hold both buttons
during power-up.