Quick Start Guide
2
Basic Connections
Here’s how to “bench test” your mixer – just plug in some cables and put
sound through it. If desired you can skip directly to the
Installer’s Reference
section which fully describes installation details, but the experience you gain by
working through this section may help when installing the unit:
Place your
VGM-1041
on a table or other flat surface.
Audio Source
– Using a stereo RCA cable (the sort that often comes with audio
components), connect a CD player or a similar “line level” audio source to both
AUX
inputs.
Amplifier
– Connect your amplifier’s balanced, line-level (not mic-level) input
to it to the mixer’s MAIN balanced output. Leave the amplifier switched OFF
for the moment.
MAIN
OUT
MAIN
OUT
MUSIC
OUT
MONITOR
OUT
Connect your
amplifier here
Balanced 3-Wire
Cable, Shield goes
to the middle.
Strip ¼”
insulation
from wires.
Insert bare wire.
Close lever.
AUX 1
AUX 2
Plug in your sound
source here
MIC 10
AUX
OUT