7
4) Camera setup (How to enter into OSD menu)
- OSD (On Screen Display) control
This controller can be used to control speed dome camera, ptz dome
camera with OSD menu.
Please, refer also to camera OSD menu to avoid conflict in
settings.
- How to enter into OSD Menu
Pressing numeric keypad 1 and MENU button respectively enable
OSD (On Screen Display) Menu to mark on the monitor.
•
The delay time between push 1 button and MENU button is about
2-3 sec.
- The shift of cursor in OSD is as follows.
¬
Left cursor - Joystick pan left (For speed dome camera only)
-
Right cursor - Joystick pan right (For speed dome camera only)
®
Up cursor – Joystick tilt up (For speed dome camera only)
¯
Down cursor - Joystick tilt down (For speed dome camera only)
°
Enter F/F button (For speed dome camera, ptz dome camera)
±
ESC – F/N button (For speed dome camera, ptz dome camera)
²
Up cursor – Z/I
button (For ptz dome camera only)
³
Down cursor – Z/O button (For ptz dome camera only)
- How to save and quit in OSD.
Keypad “1” + “MENU”
After setup or change parameters, press again numeric keypad 1 and
MENU button respectively enable OSD(On Screen Display) Menu to
mark on the monitor.
•
The delay time between push 1 button and MENU button is about
2-3 sec.
5) Preset Point
The controller makes to memorise 64 sets of the individual preset
position for each camera.
The memorised preset point is available in resetting of power, and it
can be changed.
- Starting the preset mode
SET + Keypad 1-64 + PST
This mode enable pan/tilt and zoom/focus far/near work by joystick.
Thus it can move the point of setting. After put and stop it in place you
want to surveillance, and set it following these orders.
Appoint preset point no. of the present position with keypad. Operate
with joystick and zoom, focus button, and press the PST button, then it
memorises the number 1 Preset. At this moment, it also memorises
brightness, BLC, WDR, S-BLC. If you want to memorise another
position with preset point, move to the joystick and repeat. The input
will be ignored, if preset no. Input is out of range between 1-64.
- Movement to a preset point
Appoint preset point number with numeric keypad. Appoint the number
of preset of 1-64
Ü
Pressing the PST button automatically enable it to
move to appointed point.
When the error occurs, two times of beep sound.
- Deleting each preset
Press the CLR button for a while (more then 3sec)
Keypad 1-64
Ü
PST button
Ü
ENT button
Ex) deleting the number 5 of preset:
CLR (more then 3sec)
Ü
Keypad 5
Ü
PST button
Ü
ENT button
- Deleting all preset
Press the CLR button for a while (more then 3sec)
Ü
PST button
Ü
ENT button.
