Wire Rope Hoist
PAGE: 33
Model WR
WR-0214
2721 NE 4
th
Ave Pompano FL, 33064 | (954) 367-6116
Visit WWW.ACIHOIST.COM for the most current information
5.3 Before Operating the Hoist and Applying the Load
Be familiar with all operating controls of the hoist.
Be familiar with the OPERATION procedures of this manual, the
WARNINGS
are embraced in this manual, also
the procedure of instructions and warnings labels on the hoist and lifting system.
Be instructed in the operations being performed.
DO NOT
operate hoist if any damage or malfunctions exist; and SHOULD report any damages or malfunctions to
the supervisor.
DO NOT
operate if tagged with an out of order sign.
DO NOT
use the hoist wire rope as a sling to wrap around the load.
Attach the load to the hoist hook by proper means such as slings or lifting devices.
Only attach the load to the hoist hook that does NOT exceed the rated load capacity of the hoist.
Confirm that the size of the attachment of the sling or the other lifting device to be used is compatible to the size
of the hoist hook.
Confirm that the attachment part of the sling or other lifting device is properly seated in the base, bowl, or saddle
of the hoist hook.
Confirm that the hook latch operates properly and that the hook latch properly bridged and closes the hook
throat opening.
Confirm that the latch of the hoist hook will not support any part of the load.
Confirm that the load or any part if the load will not be applied to and /or not supported by the tip of the hook.
Confirm that load will be properly balanced when it is lifted.
Confirm that the hoist wire is not kinked or twisted, and that the wire rope parts are not twisted about each other.
Confirm that hoist wire rope is properly seated in the drum grooves and sheaves.
Notify personnel in the area that a load will be lifted and verify that all personnel are clear of the load.
Confirm that when the load is lifted, it will clear all material, machinery, or other obstructions in the area.
5.4 While Operating the Hoist and Moving the Load
DO NOT
engage in any activity that will divert the attention of the operator.
DO NOT
lift, lower, or transport a load and hoist until the operator and all other personnel are cleared load and
the path of the load.
Confirm that the load and hoist will clear all obstacles before moving or rotating the load.
Avoid moving loads over personnel.
DO NOT
lift, lower, or transport personnel by the hoist, trolley, hoist hook, or load.
Slowly inch the hook into engagement with the load to eliminate wire rope slack and reduce impact loading of
the hoist.
Avoid unnecessary inching and quick reversals of direction.
Only lift the load a few inches to confirm that the load is properly balanced before continuing with the lift.