Remote Control Systems
PAGE: 18
200, 400, and 500 Series
Remotes-0214
2721 NE 4th Ave Pompano FL 33064 | (954) 367-6116
Visit WWW.ACIHOIST.COM for the most current information
6.0 ID-CODE REMOTE SETTING (500 SERIES)
The use of Copier (500 Series)
1.
Insert the six (6) pins of the female plug into the male socket inside the TX or RX of the 500 Series.
2.
To copy and save the data from TX or RX, put the magnetic key onto the receptor to connect. To transfer
the saved data from the copier to TX or RX, release the magnetic key from the receptor.
3.
Press and release the "1" pushbutton (or 2 or 3) to copy and save the data (when the magnetic key is
on) from TX or RX, after the green indicator light has flashed, the transfer is finished, disconnect the
plug. Complete the same procedure to transfer the data from copier to TX or RX (when magnetic key is
off). Note:
(1) Make sure the power of TX or RX is off when copying.
(2) The copier can copy both function settings and ID-Code, but to pair the crystal is still essential to
match both TX and RX for communicating with each other.
ID-Code Remote Setting (500 Series)
ID-Code remote setting allows you to pair the new TX or RX if one of them is damaged. Using ID-Code remote
setting will allow both the TX and RX to have the same ID-Code.
Please make sure the following conditions are met before ID-Code remote setting:
1.
Both TX and RX are of the SAME model and frequency.
2.
Place the transmitter as close as possible to the receiver to avoid interference.
3.
Turn off the RX power for at least 10 seconds and turn it on again.
ID-Code Remote Setting Instructions
1.
Press and hold the transmitter EMS button and "UP" pushbutton.
2.
Press "DOWN" pushbutton four (4) times and then release "EMS
&
UP" push buttons when the red light
on the transmitter is flashing.
3.
Start the system as you usually would.
