background image

Use these instructions to install an in roll tube cable return on 2 or 3” roll tube. Read 

and follow these instructions along with the standard instructions carefully before 

installing or using tarp system.

NOTICE TO INSTALLER:

 Even if familiar with hardware, read instructions prior to 

installation as improvements may be made without notice. Always handle components 

with care. If you have questions or problems, call customer service. When done, these 

instructions must be given to the consumer.

NOTICE TO CONSUMER: 

Before using this product, read special instructions. Save 

these instructions for future reference.

IN ROLL TUBE CABLE RETURN

Questions? 800-233-4655

agricover.com 

Summary of Contents for 80493_E

Page 1: ...familiar with hardware read instructions prior to installation as improvements may be made without notice Always handle components with care If you have questions or problems call customer service When done these instructions must be given to the consumer NOTICE TO CONSUMER Before using this product read special instructions Save these instructions for future reference IN ROLL TUBE CABLE RETURN Qu...

Page 2: ...rind smooth any sharp edges and points NOTE Components and hardware appearance may vary 1 ASSEMBLING RETURN NOTE For best adhesion ensure air and surface temperatures are above 60 F A Unfold return assembly and apply adhesive supplied in kit around male end of PVC connection B Slide PVC tubes together tape joint and let adhesive set dry time will vary depending on environment NOTE Handle joint wit...

Page 3: ...groove inside roll tube and tap in place B Use hole in end plug to insert 8 x 1 2 Phillips self drilling screw at end of roll tube STEEL ROLL TUBE NOTE Tarp clip s self drilling screws need to be replaced with shorter 1 4 x 3 4 Phillips screws supplied in kit A Carefully insert return assembly into roll tube Gently tap end plug into roll tube TIP Rotate roll tube with screws on top for easier inse...

Page 4: ...or wind deflector ensure cable does not get caught on corner of end cap or latch plate A Place guide 1 2 back from edge of latch plate Mark and drill 2 5 16 holes Fasten guide with 2 3 8 x 1 self threading hex bolts 1 2 Guide 3 8 x 1 Self threading hex bolts Latch plate B Open and close tarp several times Make adjustments in knot location if needed Path of cable Cable ...

Reviews: