2
PREPARATION
COMPONENTS
• Return assembly with hardware
• Guide with hardware
• End plug with hardware
• Adhesive packet
TOOLS NEEDED
• Drill with 5/16” bit
• 9/16” Socket and wrench
• #2 Phillips head driver
• Rubber mallet
• Marking pen
• Tape
• Protective eyewear
NOTE:
Inspect path of cable. Remove or grind smooth any sharp edges and points.
NOTE:
Components and hardware appearance may vary.
1: ASSEMBLING RETURN
NOTE:
For best adhesion, ensure air and surface temperatures are above 60° F.
A. Unfold return assembly and apply adhesive (supplied in kit) around male end of PVC
connection.
B. Slide PVC tubes together, tape joint and let adhesive set (dry time will vary depending
on environment).
NOTE:
Handle joint with care.
Guide
End plug
Return tubes
Apply adhesive on male
end of return tube
Cable