12
13
2: ASSEMBLING SNOWPLOW
(Continued)
V. Attach rubber box end and metal end plate to end of blade with (4) 3/8" x 2-1/2" hex
bolts.
W. Tighten all bolts until rubber begins to compress to blade. Insert 3/8" x 1-3/4" hex
bolt to tighten bottom of rubber to bottom of end plate. Secure with washer and nylock
flange hex nut.
X. Tighten all bolts equally. Repeat box end assembly on opposite side.
3/8" x 2-1/2" Hex bolt
3/8" x 1-3/4" Hex bolt
3/8" Nylock flange hex nut
NOTE:
To determine position of set collar, select hole in interceptor shaft which places
plow closest to vehicle while allowing blade to angle.
Y. Push set collar tight against receiver, hold and tighten set screw with 3/16” hex key.
Receiver
Tighten set collar with
3/16" hex wrench
Interceptor
ELECTRIC WINCH:
Refer to Step 2A in winch instructions to complete installation.
13
3/8" Flat washer
Summary of Contents for SNOWSPORT HD Utility Plow
Page 4: ...4 PARTS DIAGRAM Blade marker Lift handle End plate Box end ...
Page 15: ......