2
PREPARATION
Unpack snowplow components. For additional installation assistance, go to
mysnowsport.com for install and operation videos.
COMPONENTS
• (2) Box ends
• (2) Slide hinges
• (2) Blade markers with hardware
• (2) Lift handles
• (2) Shims
• Front mount with hardware
• Push frame with hardware
• Angle interceptor kit
• Upper aluminum blade
• Lower aluminum blade
• Rubber cutting edge
• Quick pin set
• Set collar
• 5/8" x 3" Receiver pin
• 5/8" x 3" Swivel pin
• Hair pin
TOOLS NEEDED
• (2) Short 2x4 sections
• Drill with 5/16” bit
• 9/16” socket with ratchet or impact driver/
wrench
• Ft-lbs Torque wrench with extension
socket
• 3/4” Box wrenches
• 3/4" Socket
• 3/16” Hex key
• Bubble level
• Locking pliers (optional)
• Protective eyewear
NOTE:
Prior to plow assembly, park vehicle on level grade and install front mount
receiver. Clearance under front or rear receiver should measure between 8-16" above
grade.
!
CAUTION: Over torquing hardware may damage components.
Summary of Contents for SNOWSPORT HD Utility Plow
Page 4: ...4 PARTS DIAGRAM Blade marker Lift handle End plate Box end ...
Page 15: ......