aci SNOWSPORT HD Utility Plow, Installation Instructions Manual

6

1: INSTALLING PUSH FRAME

NOTE:

 We recommend performing this 

step with two people. One person holds the 

push frame to the interceptor while another 

performs the installation.
A. Insert interceptor into receiver with push 

frame mounting bracket facing up and secure 

with receiver pin. 
B. Hold push frame against interceptor. 

Select (4) bolt hole pattern that positions 

push frame 8-10” above grade. 

Push frame 

clearance 8-10”

Push frame

(4) 1/2” 

x 4” Hex 

bolts 

(8) Flat 

washers 

(4) Lock 

nuts

Receiver

clearance 8-16”

NOTE:

 In some cases, clearance under receiver may be less than 8". If so, plow will still 

operate properly, but ground clearance will be limited. Use care on uneven surfaces.

NOTE: 

If lowest bolt pattern is too high, remove interceptor and reinsert with push frame 

mounting bracket facing down.

ELECTRIC WINCH: 

Slide winch assembly 

onto push frame aligning bolt holes.
C. Insert (4) 1/2” x 4” hex bolts through push 

frame and interceptor mounting holes

.

D. Verify (4) bolt hole pattern provides 

correct push frame clearance, 8-10" above 

grade, then level push frame horizontally.

Bubble level

8-10”

8-10”

E. Check push frame for vertical plumb. 

• 

If plumb, secure (4) 1/2” x 4” hex bolts with 

(8) flat washers and (4) lock nuts. Torque 

(4) nuts to 90 ft-lbs and go to Step 1I.

• 

If not plumb, perform Steps 1F-H to correct 

with shims.

Bubble level

Mounting 

bracket