Timer Function
TIMER ON
(to start the unit) and
TIMER OFF
(to stop the unit) can
be used separately or together.
Timer ON only
This function allows the unit to start automatically at the set time.
The
TIMER ON
can be set while the unit is on or off.
UNIT ON
a. Press the
TIMER ON
button to initiate the auto-on time
sequence. The set time is displayed in the remote control
display. Every time the
TIMER ON
button is pressed, the time
increases by 30 minutes, up to 10 h. It increases by 60
minutes, afterwards, until the time setting reaches 24 h.
b. When the
TIMER ON
is set, the
TIMER
light on unit
illuminates. The unit continues to run at the set time.
UNIT OFF
a. Set the timer described in the
UNIT ON
section.
b. The unit starts at the set time.
Adjust the
TIMER ON
settings to
0.0
to cancel this option.
Timer OFF only
This function allows the unit to stop automatically at the set time.
The timer can be set while the unit is on or while it is off.
UNIT
ON
a. Press the
TIMER OFF
button to initiate the auto−off time
sequence. The set time appears on the remote control display.
Every time the
TIMER OFF
button is pressed, the time increases
by 30 minutes, up to 10 h. It increases by 60 minutes, afterwards,
until the time settings reach 24 h.
b. When the
TIMER OFF
is set, the timer light on the unit
illuminates and the unit turns off automatically at the set time.
UNIT OFF
a. Set the
TIMER
off as described in the
UNIT ON
section. The
TIMER
display on the unit illuminates and the unit remains
off.
b. Adjust the
TIMER ON
settings to 0.0 to cancel this option.
Timer ON and Timer OFF
Use both functions to program the unit to turn on and shut off at
specified times.
UNIT OFF
a. Set
TIMER O
N as previously described.
b. Set
TIMER OFF
as previously described. The unit starts
automatically at the set
TIME ON
and turns off at the set
TIME OFF
.
UNIT ON
a. Set
TIME OFF
as previously described.
b. Set
TIME ON
as previously described. The unit turns off
automatically at the set
TIME OFF
and turns on at the set
TIME ON
.
Sleep Mode
SLEEP
mode is used to conserve energy and can be used when
the unit is in the
COOL
,
HEAT
or
AUTO
mode only.
Cool Mode
a. Push
SLEEP
. After 1 hour the set point raises by 1.8F
(1C). After another hour, the set point raises by another
1.8F (1C) and the fan runs in a low speed. The unit shuts
off 5 hours after setting the
SLEEP
mode. The
SLEEP
mode cancels if either the
“Mode”
,
“TEMP”
,
“Fan”
,
“Timer”
, or
“On
/
Off”
buttons on the remote control is
pressed.
Heat Mode
Same as
COOLING
mode however set points are lowered by
1.8F (1C).
Turbo Mode
Use the
TURBO
mode to cool or heat the room rapidly.
a. Press
TURBO
. An audible “beep” is heard if the indoor unit
supports this function. The fan runs on super high speed. The
TURBO
mode terminates automatically 20 minutes after
pushing
TURBO
. It can be terminated immediately by pushing
TURBO
again. When the
TURBO
mode is terminated, the unit
reverts to the original setting.
Page
1
3