-
2
-
HARDWARE INSTALLATION
1.
Plug the antennas in
Plug the 2 antennas of your choice (not included) into the Ant.1 and Ant.2
connectors.
For single antenna installation, use Ant.1 connector.
For dual antenna installation, use Ant.1 and Ant.2 connectors.
WARNING: It is recommended to connect a 50 ohms terminator on
unused antenna connector. If not, it may disturb radio link quality and
data throughput, and as well as waterproofness.
2.
Connect the power supply
The device has 2 sources of power supply:
Power through M12 PWR connector
PoE through M12 LAN connector
See the “
specifications”
section about the characteristics of the power supply.
The device has no ON/OFF switch. It turns-on automatically when power is
applied. Check LED Power
ON if main power supply or PoE source is ON.
The Diag LED stays red for around 60 seconds, until the device is fully ready
to use. Then the Diag LED turns green.
3.
Connect the Ethernet cable
Plug the Ethernet cable to the device’s LAN M12 connector.
Check that the corresponding LAN LED turns ON at that point.
