23
y
Four rows will show as follows:
–
1:
SATA 1 Port
–
2:
SATA 2 Port
–
3:
SATA 3 Port
–
4:
SATA 4 Port( B type model only )
Format
y
You must format when you:
–
install new HDD
–
add another HDD
–
replace HDD
–
move HDD (change installation port)
–
remove HDD
y
Click (
) Add/Remove frame in Format column, and choose ‘OK’ on the dialogue box to start formatting.
y
Following format, DVR will auto-reboot. If there are more than 2 HDDs, please format each of HDDs. DVR will auto-reboot
when all the HDDs are formatted.
y
If the frame changes to ‘---‘ after reboot, it means formatting has been properly done.
S.M.A.R.T
y
Click the frame on S.M.A.R.T column, and temperature and HDD damage will show.
S.M.A.R.T Setup
y
Please click (
) S.M.A.R.T Setup, and the following screen will appear.
y
Check the square box
5
next to Use On. Through S.M.A.R.T function, make alarm message, indicating HDD damage, will
show.
y
Check
5
Beep, it will give the alarm sound, indicating HDD damage, as the SMART setup.
y
Check
5
Blink Message, the alarm message will blink on the OSD, as the SMART setup.
y
If you uncheck Used on, Beep, Blink Message will be unchecked automatically. Only when you check
5
Used on, you can
set Beep, Blink Message function.
y
Click (
) Inspection Time frame to set inspection time.
y
Click Check by frame to select inspection interval.
y
Last Check Time: show the time of the last inspection.
y
Click (
)
▲
,
▼
direction buttons on the right-hand side of Temperature frame to adjust to maximum temperature for the
HDD used in DVR. In general, it is
55
℃
.
y
Click (
)
▲
,
▼
direction buttons on the right-hand side of HDD Damage frame to set the permissible level of HDD damage
(%). HDD is a very crucial element for DVR recording, so set the permissible level within 1% to 2% to assure maximum
safety.
While pressing (+) or (-) button on the rightmost side of Temperature or HDD Damage item, a target value increases or
decreases by 10 units.
y
Choose ‘OK’ to confirm the setting.
CAUTION
EXECUTE REMOVE PROCEDURE EVEN WHEN YOU REMOVE PREVIOUSLY INSTALLED HDD. THE REMOVE PROCEDURE IS
THE SAME AS THE FORMAT PROCEDURE DESCRIBED ABOVE.
