21
Setting of coffee and hot water portions
Programming is done on standby machine ready to operate.
Programming begins pressing the key E on the touch pad on left side of the machine from operator side.
a. Press key E on the touch pad for more than 5 seconds.
b. Release key E and press the key to be programmed (A B C D F ). The led on the key lights on
and erogation begins.
c. When the wished quantity is reached (coffee or hot water) press the lighted key and the erogation
stops.
d. Repeat the sequence from a to c on every single key of the touch pad on left side of the machine
from operator side.
e. To exit from programming press key “E”.
Note
: By programming the touch pad on left side of the machine from operator side, the same quantities are
automatically set on the second touch pad as far as coffee is concerned. Hot water portions are to be set on every
group.
If you want to program the other touch pad with different quantities, it is necessary to repeat the programming
sequence pressing the key E on the second touch pad.
For the perfect programming of coffee we suggest you to prepare a coffee using fresh and duly grinded coffee to
be put in the cup that will be used during regular operation.
Switching off the machine
Turn the general switch (fig.1,4) from position 2 to position 0.
Note
: If the espresso machine Teknica is not used for a longer time, it has to be switched off, disconnected from
electrical supply and water mains. The boiler must be completely emptied. The machines has to be carefully
drained and stored in a dry location which is inaccessible to minors.
The machine must be dismantled by an authorized technician according local law and jurisdiction.
