English –
E
EN
PREDISPOSITION OF THE QUICK MOUNTING BRACKET
A) Fix the wall bracket;
B) Attach the spring in the groove of the motor head;
C) Hook the motor head in the seat bracket.
Figure 6 illustrates that whatever the type of installation (right or left), screw "A" regulates the downward movement
and screw "B" the upward movement. Move the rolling shutter (or awning) down by pressing the button. If the rolling
shutter does not reach the position required, turn screw "A"
clockwise
and with the button pressed down, bring the
rolling shutter down to the position required. If, instead, the rolling shutter stops below the position required move
it back up using the control button and then turn screw "A" in a
anticlockwise direction
to reduce the travelling di-
stance so that even if the button is pressed the rolling shutter remains stationary.At this point repeat the operations
described for the top position of the rolling shutter. Press the button to wind the rolling shutter up. If the stop position
of the rolling shutter is too low turn screw "B"
clockwise
until it reaches the position required. If the rolling shutter
stops in a position that is too high,turn screw “B”
anticlockwise
to reduce the travelling distance.
FIG.4
CONNECTIONS
ADJUSTING THE TRONIX Ø35- Ø45 LIMIT SWITCH
1 - BIANCO
2 - BLUE
3 - MARRONE
4 - NERO
5 - GIALLO/VERDE
L
N
WINDY
FIG.5
1
2
3
4
5
CONNECTIONS
WHITE-Input of sensors
BLUE-Neutral
BROWN-Phase
BLACK-External switch
YELLOW/GREEN-Ground
Summary of Contents for TRONIX 13
