ACM TRONIX 13, Instructions And Warnings For Fitters

E

 – English

EN

TX-PLUS2: 

• Press the STOP + UP + DOWN keys of the channel to be programmed 

• When the LED lights up, release all the keys 

• Programming is activated for 30 seconds 
TX-PLUS4: 

• Press and release the key relative to the channel to be programmed, the LED will light up 

• Press the STOP + UP + DOWN keys, the LED goes off 

• When the LED lights up, release all the keys 

• Programming is activated for 30 seconds 

Note: this procedure will be the same for the programming of all functions and will not be repeated in the 

following paragraphs 

NOTE: to activate the programming only 1 channel must be selected. 

Below is the list of programmable functions and the number of corresponding flashes during the programming phase

TX-PLUS

NUMBER OF 

FLASHES

1

2

3

4

5

6

7

8

9

TX-FIT1

NUMBER 

OF LED

L1

L2

L3

L4

L5

L6

L1+L2

L3+L4

L5+L6

FUNCTION

Transmitter memorization and sunshade shutter mode selection

Transmitter memorization and roll-up shutter mode selection

Deletion of all memorized transmitters

/

/

/

Wind sensor intervention threshold

/

/

TRANSMITTER DATA STORAGE AND SELECTION OF THE SUNSHADE/ROLL-UP SHUTTER MODE CAUTION: 

The data storage of the first transmitter determines the direction of motion of the motor. 

To store a transmitter on a virgin control untit proceed as follows: 
1. Supply power only to the control unit to be programmed 
2. Activate the TX-PLUS / TX-FIT1 programming 
3. To select the SUNSHADE mode press the UP or DOWN keys until the led performs n. 1 flash (select the L1 for TX-FIT1)
To select the ROLL-UP SHUTTER mode press the UP or DOWN keys until the led performs n. 2 flashes. (select the L2 for 
TX-FIT1) 
4. Press the UP+DOWN keys until the motor starts to move in one direction 
5. Release the keys, the motor stops 
6. Press the UP or DOWN keys according to the direction in which the roll-up shutter was moving before it stopped: 
- if the roll-up shutter was being raised press the UP key; direction obtained: the UP key raises the roll-up shutter, 
the DOWN key lowers the roll-up shutter 
- if the roll-up shutter was being lowered press the DOWN key; direction obtained: the DOWN key lowers the roll-up 
shutter, the UP key raises the roll-up shutter. 
7. To exit the programming mode press the STOP key 
8. Try to operate the roll-up shutter and verify that it works according to the logic described above. If the logic is rever-
sed it is necessary to delete all the codes stored (see “DELETION OF ALL MEMORIZED TRANSMITTERS”) and repeat the 
steps above. 
To add other remote controls you can also use the “QUICK MEMORIZATION OF TRANSMITTERS.