ACME ColorTec 250 LED-CC60, User Manual

10A

  PRO Defaults 

Select the 

, press the 

ENTER

 button and the display will blink. Use the 

DOWN

 and 

UP

button to select the 

 (run built-in program to set the fixture to factory settings) or 

. 

Press the 

ENTER

 button to setup, to go back to the functions without any change press the

 MENU

button again. Hold and press the 

MENU

 button about one second or wait for one minute to exit the 

menu mode. 

    Reset 

Press the 

MENU

 button to show the 

 on the display. Press the 

ENTER

 button and all 

channels of the unit will return to their standard position. 

5. How To Set The Unit   

You can operate the unit in three ways: 

1. By master/slave built-in preprogram function 

  2. By easy controller 

3. By universal DMX controller   

No need to turn the unit off when you change the DMX address, as new DMX address setting will 

be effected at once. Every time you turn the unit on, it will show the 

  on the display and 

move all the motors to their ‘home’ position and you may hear some noises for about 20 seconds. 

After that the unit will be ready to receive DMX signal or run the built-in programs. 

5.1 Master/Slave Built In Preprogrammed Function   

By linking the units in master/slave connection, the first unit will control the other units to give an 

automatic, sound activated, synchronized light show. This function is good when you want an 

instant show.   

2-light show 

In 

 (slave mode), 

  means the unit works normally and 

  means 2-light show. In 

order to create a great light show, you can set 

  on the second unit to get contrast movement 

to each other, even if you have two units only.