5A
3. How To Set The Fixture
3.1 Control Panel
○
1 Display: To show the various menus and the selected functions
○
2 LED:
○
3 Button:
MENU
To select the programming functions
DOWN
To go backward in the selected functions
UP
To go forward in the selected functions
ENTER
To confirm the selected functions
DMX
On
DMX input present
MASTER
On
Master Mode
SLAVE On
Slave
Mode
Sound
On
No
function
10A
4. How To Control The Unit
You can operate the unit in three ways:
1. By master/slave built-in preprogram function
2. By easy controller
3. By DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address
setting will be effected at once. Every time you turn the unit on, it will show “ wav” on the
display and move all the motors to their ‘home’ position. After that the unit will be ready to
receive DMX signal or run the built in programs.
4.1 Master/Slave Built In Preprogrammed Function
The fixture will allow you to link 2 fixtures together and operate without a controller. In
Master/Slave mode, the first fixture whose DMX input jack has with nothing connect need to
set as master and the other unit need to set as slave 1 via menu, then the first unit will
control the other to give an automatic and synchronized light show. This function is good
when you want an instant show. Any fixture can act as a Master or as a Slave.
4.2. Easy Controller (by CA-8)
The easy remote control is used only in master/slave mode. By connecting to
the 1/4” microphone jack of the first unit, you will find that the remote controller
on the first unit will control all the other units for Stand by, Function and Mode
selection
Blackout To blackout all the fixture
Function
Water wave speed:1-3
Hold and press for 3 seconds:
1. Clockwise/counterclockwise/color
2. choose color
Color speed:1-3
Mode
LED OFF
LED ON
LED blinking
