15
GB
troubleshooting
The iron emits a foul smell or gives off smoke
The iron may give off a bad smell when turned on for the first time. Oil used for coating certain
parts during manufacture need to be burnt off. Allow ten minutes for the foul smell to disappear.
The iron does not heat
The iron should be plugged into electrical outlet. The thermostat dial must be set to the desired
temperature.
The iron does not produce steam
The water tank may be empty. Turn the steam control knob to required position and add water.
Allow the iron to heat and then set it to the “Steam” position.
The “Shot of steam” feature does not work
The water tank must be at least 1/4 full. The iron must be set to the “Steam” position. The iron
should be in the horizontal position. Prime the pump briefly. Allow a short pause between shots.
Be sure to fully depress the “Shot of steam” button.
The “Water spray” feature does not work
The water tank must be at least 1/4 full. Fill the iron as described under “How to fill the water tank”.
Anti-drip function
1. Water supply is cut off automatically to prevent water from dripping from the soleplate when
the temperature of the iron is insufficient to produce steam.
2. After plugging the iron into a mains outlet, wait for 3 minutes for steam to be produced.
