- 10 -
Hanging the fixture:
Fix the fixture on a flat level surface (such as the ground or a wall):
1. Drill four expansion screw holes (for M12 expansion screws) on a flat level surface (such as
the ground or a wall) according to the size shown in Figure
①
.
2. As shown in Figure
②
, unscrew the washers and nuts of the expansion screws, and insert
the expansion screw tubes and screws into the drilled screw holes.
3. As shown in Figure
③
, align the holes on the brackets of the fixture with the four screws,
then put the washers and nuts of the expansion screws in turn and tighten them with a
wrench.
4. After tightening the nuts, check whether the fixture is installed firmly, then adjust the
fixture to the required angle through the bracket knob.
Summary of Contents for PIXEL LINE IP
Page 1: ......
Page 14: ... 13 Steps for installing the omega brackets to the fixture ...
Page 64: ... 63 LED PIXEL ZONES ...
Page 68: ......