XP-5R Beam
-
11
-
5.3 Change the Lamp
1. Follow the Fig.1 and Fig.2: Loosen the four screws and open the cover
2. Follow the Fig.3 and Fig.4: Loosen the two screws and apart the entire assembly
3. Follow the Fig.5 and Fig.6: Unplug all the connect wires over the lamp and wear
Anti-static gloves to take on the lamp
4. Change a new lamp
Fig1
Fig2
Fig3
Fig4
Fig5
Fig6
28-
7.4 DMX 512 Configuration
Please refer to below configurations to control the fixtures
Attention:
1. The unit will maintain the last condition until reset if you cut-off the DMX signal.
2. For the channel Function, keep the value for about 5 seconds, then the corresponding
function will take into effect.
www.bluelight.at
www.bluelight.at
