8/16/32 PS/2 KVM over IP switch
54
possible but you must make sure, it is not interfering with the IP settings of the PS/2
IP-KVM switch and your console computer. The default value will work in most cases.
IPMB over serial
To enable IPMB over serial, enable this option.
Passthrough access to serial port via Telnet
Using this option, it is possible to connect an arbitrary device to the serial port and access
it (assuming it provides terminal support) via Telnet. Select the appropriate options for the
serial port and use the Telnet Console, or a standard Telnet client to connect to the PS/2
IP-KVM switch .
IPM 220-L (Inline Power Module)
This is an optionally available external module to switch power of a single system by
putting it in the power supply line of the controlled system.
6.4.6 Date
And
Time
Figure 6-27. Date and Time
This link refers to a page, where the internal real-time clock of the PS/2 IP-KVM switch can
be set up (see Figure 6-27). You have the possibility to adjust the clock manually, or to use a
NTP timeserver. Without a timeserver, your time setting will not be persistent, so you have to
adjust it again, after PS/2 IP-KVM switch loses power for more than a few minutes. To avoid
this, you can use a NTP timeserver, which sets up the internal clock automatically to the
current UTC time. Because NTP server time is always UTC, there is a setting that allows you
to set up a static offset to get your local time.
