17
The whole assembly – figure 2-7 (1 & 2) is then secured to the mast with the connec
-
tors facing down using three hose clamps (3). Always secure any loose cables, guy
wires or any other object that might fall on or hit the tuner assembly.
Both mast and wall brackets have mounting holes for securing cables with the provid
-
ed cable clamps (pos. 3 in the item list). The cable clamps are mounted with bolts (pos.
11) and a combination of 2 washers (pos. 10 and 13).
Finally, slip the Weather Protection Cover
ACOM 04-WP
over the tuner – figures 2-4
to 2-7, (1) - directing it
with the protruding part (marked with ACOM) up
. Place it
over the provided four carrying pins protruding from the tuner chassis. Carefully align
the protection hood until the pins fit into the respective holes; the cover will go down a
bit and will rest on the five carrying plates in the tuner base. Check whether all walls
of the protection hood are equidistant from the tuner chassis and whether their bottom
edges are parallel.
Use the provided fixing elements in the installation kit to fix the protection hood secure
-
ly in place. Loosely screw all nuts and screws at first, then fasten them tightly.
Fig. 2-7. Securing the ATU to a mast
Summary of Contents for ACOM 04AT
Page 1: ...1 ...
Page 57: ...2 2 ...