ACONATIC 32HS521AN, Manual

8

Switching on

Follow the instructions on this page on how to switch on your TV set and the remote 

control before going on to following pages describing how to use the channel set-up 

procedure.

1. Insert two batteries in the remote control.
    Precautions on using batteries:

    - Only use the battery types specified.

    - Make sure you use the correct polarity.

    - Do not mix new and used batteries.

    - Do not use rechargeable batteries.

    - Do not expose batteries to excessive heat such as sunshine, fire or the like, 

      throw them in a fire, recharge them or try to open them, as this could cause 

      them to leak or explode.

    - Remove the batteries from the remote control if you are not using it for a long 

      period of time.

3. Connect an outside aerial to the 

ANTENNA IN 

socket at the back of the TV set.

4. When powered on, the TV will be turned on directly or be in standby.

    Note: For some models, swi

tch the TV on by pressing the power button.

   If the power indicator lights up, the TV set is in standby mode. Press the     

    button on the remote control or on the TV set to turn on the TV.    

2. Connect the power cable 

FIRST

 to the television, 

THEN

 to a mains socket.

    (Note: If the power cable is connected to the television, please only connect the 

    power cable to the mains socket.)
     If your TV is connected to an AC supply

     Your TV set should only be connected to an AC supply. It must not be connected 

     to a DC supply. If the plug is detached from the cable, do not, under any 

     circumstances, connect it to a mains socket, as there is a risk of electric shock.
     If your TV is connected to a DC supply

     Your TV set should only be connected to a DC supply. It must not be connected

     to a AC supply. If the plug is detached from the cable, do not, under any

     circumstances, connect it to a mains socket, as there is a risk of electric shock.

Switching off

To put the TV set into standby mode, press the     button on the remote control

or on the TV, the TV set remains powered up, but with low energy consumption.
To switch off the TV set, unplug the mains socket from the mains outlet.

Note: For some models, press the power button to switch off the TV set .