Power Your Green Life!
www.ACOPower.com
4120 Valley Blvd Walnut, CA 91789, USA
+1-626-737 1140
What are you going to use it for
1. Charge solar generators
1.1. Charge 12V Solar Generator with built-in Charge Controller
Step 1: understand your solar generator and prepare the MC4 adapter for your solar generator
Step 2: Disconnect MC4 Connectors and let it to be a solar panel with MC4 connectors
Step 3: Use your MC4 Adapter to charge your solar generator
2. Charge your 12 Volt battery
The solar panel kit is designed to charge a large range of batteries including Sealed, Flooded, GEL, AGM, Lithium,
lead-acid battery and other deep cycle battery. The batteries are used as car battery, RV battery, boat battery and
emergency back-up battery.
Step 1: understand your battery: battery type, capacity and voltage
Step 2: check the charge controller’s set up. We have defaulted the setting of the charge controller is for SEALED.
(AGM is also included in SEALED type.) If your battery’s type is different, please set your battery type with the
charge controller following the instructions below.
When you combine two solar panels in parallel, the current from the two solar panels are added together and this will
enable the battery to charge faster. For more information about adapters needed, please contact us.
3. Connect in parallel with another solar panel to charge a 12V battery faster
Warning: Make sure the combined current is lower than the rated current of the charge
controller which is 10 amps for this model.
Lead-acid Battery
Lithium
Battery
HY-PTK-100Exp
