INSTA
LL
ATION
OF
H
AN
G
IN
G
P
L
ATE:
DC-368H
Remove one screw from the motor round piece, unscrew the other two
screws out by 3 to 4mm.
A�ach the lightkit to the fan, fix the first screw back to the hole and �ghten
all the three screws firmly (fig 11).
Direct plug in the wire to the lightkit docking/connector (fig 12)
*skip this step if using decora�ve cover.
A�ach the acrylic cover / decora�ve cover to the lightkit and twist clockwise
un�l its secured �ghtly (fig 13).
1)
2)
3)
4)
To use four Expansion Setscrew to
install the Hanging Plate (fig 14).
*AC wires must pass through the
hanging plate center hole.
Install the ‘J’ hook onto the
concrete and fastened firmly.
1)
2)
INSTALLATION OF LIGHTKIT:
fig 13
fig 12
fig 11
fig 14
9
